[. . . ] before using the appliance , check that the mains supply voltage corresponds to the voltage indicated on the rating plate. Connect the appliance to an efficiently earthed power supply and sockets with a minimum current rating of 10 A only. However, you are recommended to top up the water in the tank immediately. [. . . ] However, you are recommended to top up the water in the tank immediately. When the "no water" light comes on, you should not continue steam ironing with the pump vibrating. If this practice is continued, in the long run it could irreparably damage internal components. Symbols used in these instructions Important warnings are identified by these symbols. Failure to observe the warning may result in life threatening injury by electric shock. If in doubt, do not use the appliance and contact qualified personnel only. Ding children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children must be supervised to ensure they do not play with the appliance. The appliance must be used and rested on a stable heat resistant surface. rinsing the steam generator After every 10 ironing sessions , proceed as described on page 6. Disposal In compliance with European directive 2002/96/EC, the appliance must not be disposed of with household waste, but taken to an authorised waste separation and recycling centre. Water has condensed inside the tubes because steam is being used for the first time, or has not been used for some time. the ironing system is positioned on an unstable and/or sloping surface. The first time the appliance is turned on, you notice smoke The appliance emits an intermittent noise associated with vibrations. chemical water softeners or additives have been poured into the water tank or steam generator. Some parts have been treated with sealer/lubricant which evaporates the first time the iron heats up. [. . . ] chemical water softeners or additives have been poured into the water tank or steam generator. Some parts have been treated with sealer/lubricant which evaporates the first time the iron heats up. rEMEDY Make sure the appliance is correctly connected and press the iron and steam generator buttons. [. . . ]